Search results

I'm having a big ass problem saw cutting Alumiuim Bronze. 8" Solid. Hydro-mech horizontal saw. I've tried course blades, fine blades, carbide tooth blades. All the variations of feeds and speeds. Best result is brand spankin' new blade (no break in) feeds and speeds similar to alloy steel. But...

As the title says....is there a way to control a groove width using comp. at the control? I'm using Mastercam to generate code, it does spit it out with G42 (41), and the control (Haas) doesn't refect it. My OD groove tool orientation is defined as 6. When I add a value to Z wear I only get...

Any of you guys done this? M16x2 tapped hole. Part went to Nitride and the holes weren't masked. Chasing it with a tap is nogo. Just wondering if anyone had a trick or experience. These parts can't be scrapped out. I read about etching Nitride with a hot peroxide solution too. Again zero...

Wondering if anyone has really dug into one of these, in order to indentify the rigidity loss. (Insert shipping container joke here). I've never been an advocate for Haas machines, but never really hated them either. I think they have their place. ... But I'm running this Lathe and it's giving...

I'm working in a Hyundai-Kia skt 21 lms (no Y axis). The sub is not in line with the main. I've been fucking around with it all day. It appears (note that I could be and regularly am wrong) but it appears as though the sub is on a pivot pin. So I can fix taper with push/pull screws and bolts...

Just wanted some general Fusion vs ______, whatever. I use Mastercam, Gibbs and Esprit right now. But for $500.00 a year, the effective price point is huge. I have to assume, it can't be as well supported as the big names. But I've had moments on the phone with inhousesolutions where I would've...

http://www.yodermachinery.com/search.aspx?ti=72655&cat= I'm considering buying this for my garage. Just wanted some opinions. You can look it up on Youtube, it runs through all speeds. Problem is; if I want to buy a RPC or not....