alphonso
Well-known member
Think tailstock.
Another two hours and I've got turret clocked to .001 TIR X and Y. I think it will work.
Another two hours and I've got turret clocked to .001 TIR X and Y. I think it will work.
0TC Unexpected action
- Thread starter alphonso
- Start date
alphonso
Well-known member
Not from the OEM. 8.66 X 18.11 "machining envelope".
I don't like using G70. I don't have as much control of the Finish pass. Copy and paste the profile, then enjoy taper control, minor edits, etc.
I keep the taper pins after I remove them from EVERY slant, for quick close counts stuff. But dialing it back in isn't huge thing. Couple hours or less once you've done it 5-10 times. Unless the Hirth is damaged.
R
I keep the taper pins after I remove them from EVERY slant, for quick close counts stuff. But dialing it back in isn't huge thing. Couple hours or less once you've done it 5-10 times. Unless the Hirth is damaged.
R
Spruewell
Well-known member
- Joined
- Mar 6, 2021
- Messages
- 674
- Reaction score
- 441
Really? You can add taper control (U, W) into the G71/G72 cycle and the G70 finish cycle will pick it up just fine. Minor edits too. I’ve even had a G70 cycle only finish parts of the G71/G72 cycle. Just pick the lines you want it to start and stop. The requirement for X and Z to be either continuously increasing or decreasing presents some limitations in grooving and reliefs, but that’s not difficult to deal with
Then I'm doing it wrong. I cannot, can NOT under any variation that I've tried, add a U value for taper to the defined profile.
And there are times that I don't want the basic roughing profile changed, but I do want the finish pass changed.
R
Jaas (spanish for Haas). Settings are for Fanuc. I understand they aren't exact, but no Fanuc control is identical.
I'll run into it and post a new topic later.