alphonso
Well-known member
Think tailstock.
Another two hours and I've got turret clocked to .001 TIR X and Y. I think it will work.
Another two hours and I've got turret clocked to .001 TIR X and Y. I think it will work.
Then I'm doing it wrong. I cannot, can NOT under any variation that I've tried, add a U value for taper to the defined profile.Really? You can add taper control (U, W) into the G71/G72 cycle and the G70 finish cycle will pick it up just fine. Minor edits too. I’ve even had a G70 cycle only finish parts of the G71/G72 cycle. Just pick the lines you want it to start and stop. The requirement for X and Z to be either continuously increasing or decreasing presents some limitations in grooving and reliefs, but that’s not difficult to deal with
Jaas (spanish for Haas). Settings are for Fanuc. I understand they aren't exact, but no Fanuc control is identical.Well. I don’t know what to say. Maybe it’s a parameter setting. What control are you running? I’ve run OT (late 80’s) and Oi-TC ~2005 and have not run into an issue.