Herding Cats
Hardplates
When a Pro 3 (18iMB) in in M250 (251 exc) operating with G8 or G5 (SG or SGI) should the pre read blocks be highlighted or change color on the control?
Last edited:
Makino Pro 3 Look-ahead
- Thread starter Herding Cats
- Start date
mach ramsey mn
Active member
Find anything out on this? I believe On the fanuc controls when you turned on the HPCC, the look ahead displayed on the screen was not accurate as the screen was the last thing updated. If you had a real high point density the screen would look like it froze until you hit a longer stretch that had a low point density so the screen would “catch up.”