I need to cut 60 sensor target teeth into a 2.7" blank (lots of them). I'd rather not tie up a mill and indexer just doing this- I have a Hobber!
I'd like to use a cheap, off the shelf hob. The teeth are too small on Mod 1 or 24DP. Mod 1.25 or 20DP don't work out. 22DP is pretty darn close though.
I get 2.8181" outside diameter, 2.6135" for 22DP 60 teeth. 22DP hubs don't look hard to get. What would the teeth look like if I moved that hob in to cut the same teeth in a 2.7" blank?
Would it leave little slivers of teeth or would they still look like gear teeth?
I might be able to get away with 59 teeth which would be 2.7726"
Again, not making gear teeth. Just need teeth-shaped targets for a sensor to read. I'll be milling 2 teeth off of a 60 tooth wheel to make it a 60-2 and I can probably fudge a 59 tooth wheel to work as well. I can't do a 58 tooth wheel. The ECM has to see the missing tooth pulse.
I'd like to use a cheap, off the shelf hob. The teeth are too small on Mod 1 or 24DP. Mod 1.25 or 20DP don't work out. 22DP is pretty darn close though.
I get 2.8181" outside diameter, 2.6135" for 22DP 60 teeth. 22DP hubs don't look hard to get. What would the teeth look like if I moved that hob in to cut the same teeth in a 2.7" blank?
Would it leave little slivers of teeth or would they still look like gear teeth?
I might be able to get away with 59 teeth which would be 2.7726"
Again, not making gear teeth. Just need teeth-shaped targets for a sensor to read. I'll be milling 2 teeth off of a 60 tooth wheel to make it a 60-2 and I can probably fudge a 59 tooth wheel to work as well. I can't do a 58 tooth wheel. The ECM has to see the missing tooth pulse.