Search results

  1. V

    Anyone with a Fanuc 0C look at something for me?

    If anyone here has that control, could you look at the PMC board and see if it has ROMs or ROM sockets marked 0E1 and 0E2?
  2. V

    When you don’t have a horizontal 😧.

    Would be handy at times! Fortunately I only have to drill and tap the ends.
  3. V

    Makino RMC55 help

    Bringing a private conversation to the open forum..... To use the hand wheels (Manual Pulse Generators) on an RMC55. You must be in the MPG mode. Then you must select which two axes you wish to move with the circled selector switches. In this picture I have selected X and Y for movement...
  4. V

    BT40 by 90 degree pullstuds

    I have 5 BT40 and 1 CT40 pullstuds with 90 degree shoulder. This is like older Mori Seiki machines use and probably others. Free, just pay the postage.
  5. V

    New to me day!

    Out of the weather for now. Will need a bit of re-positioning to make usable. Makino RMC55 toolmakers mill
  6. V

    What have I done!! 😵‍💫

    For some reason, in a moment of insanity, I have taken a job for 500 pieces. Last time I had to run over 20 of something at one time was some time in the early 80s. WTF was I thinking! Crap, feels like having a real job again.
  7. V

    Looking at used machines?

    Haven’t been many threads on this subject yet but as the site grows they are bound to come. Folks, when you are considering buying a used machine you are often mostly concerned about its condition. This overlooks one huge thing. Does it come with all the manuals and documentation? If not, you...
  8. V

    Multiple sides, one fixture.

    I make a range of small parts that need operations on multiple sides. Very low quantity so want get close to one part flow. I use this "tumble block" dovetail fixture to do that.
Top Bottom